WALL HUNG CLOSET
As per shown in the picture, the rag bolt must be grouted into the cement/concrete wall. The bolts must be fixed to the cement/concrete wall. Allow setting & checking than install it using nut and washer.COUNTER WASH BASIN
At the beginning
- A skilled or experienced person should install counter lavatories.
- Avoid using adhesive with this product.
- Check the waste area and supply tubing if required.
- Do not open the lavatory from its protective carton until you are ready for installation.
- Please follow all local building and plumbing codes.
MATERIAL & Tools
Measure tape, Keyhole or saber saw, Hammer, Glasses, Rags or Paper toweling, Drill (1/2 dia, drill bit or larger), Pencil, sealant, sharp knife or scissorsINSTALLATION OF COUNTER TOP
Please Note : Please install it in a way that future removal from underneath the counter top is possible without damaging the counter.
- Please check the desired location for clearance between the back splash, faucet, Fixture and cabinet.
- Please cut the template.
- Please carefully trace the template on the counter top directed.
- Please mark the faucet hole centerline on the counter top.
- Please drill a 1/2″ pilot on the inside of the cut line.
For Wood Counter Tops
- Mark and per-drill the wood screw holes at the locations shown on the template.
- Waterproof any exposed areas of wood.
For Marble Counter Tops
- Position the counter top upside down on foam padding to protect the surface. Mark and drill 3/6″ holes 5/8″ deep at the locations shown on the template.
- Use a setting tool and hammer to secure the anchors.
For Other Installations
- If the counter top has not been installed, install it at this time.
- Drill the faucet holes according to the faucet installation instructions.
- Install the faucet to the counter top according to the manufacture’s instructions.
- Install the drain to the lavatory according to the manufacture’s instructions.
